Table of Contents
Advertisement
Table 3-1: WAN/LAN/VLAN
Field Name
Description
Allow Management
Enable or disable the Local Maintenance Terminal connection through the
Access Over WAN
WAN port.
Connect Type
Used to select the type of connection for the eNB (Copper or Fiber)
MTU
Used to specify the maximum size of the network layer protocol data unit
that can be communicated in a single network transaction. Range is 700 to
1600.
DNS Address 1
Used to define the DNS 1 IP address
DNS Address 2
Used to define the DNS 2 IP address
WAN Config
Used to enable the interface. Four IP addresses are the maximum number the
eNB supports.
IP Access Mode
Used to select the desired interface protocol: DHCP, Static IP, IPv6 DHCP, or
IPv6 Static IP
Current IP
The WAN interface IP address
Option60
Used to differentiate between different terminal when IP Access Mode is set
to DHCP
Subnet Mask
Used to define subnet mask address if IP Access Mode is set to Static IP
Prefix
Prefix of IPv6 address for WAN interface if IP Access Mode is set to IPv6
Static IP
Gateway
Used to define gateway address if IP Access Mode is set to Static IP
VLAN ID
Used to configure more IP addresses for the WAN interface through the
VLAN when there is a need to transmit multi-types of data.
3.7.4.2 LGW
The Local GateWay (LGW) setting must be configured when using the Baicells CloudCore Evolved
Packet Core (EPC). Refer to Figure 3-19 and Table 3-2. You must reboot the eNB when you make
changes to these settings.
Figure 3-19: LGW
30
Advertisement
Table of Contents
