Table of Contents
Advertisement
4.
STATUS INDICATORS
The 7760VMS-HD has 9 LED Status indicators on the main circuit board front card edge to show
operational status of the card at a glance. Figure 7-1 shows the location of the LEDs and card edge
controls.
toggle
switch
Two large LEDs on the front of the board indicate the general health of the module
LOCAL FAULT:
This Red LED indicates poor module health and will be ON during the absence of a
valid input signal (on Input A or B) or if a local input power fault exists (i.e.: a blown
fuse). The LOCAL FAULT indication can also be reported to the frame through the
FRAME STATUS jumper.
MODULE OK:
This Green LED indicates good module health. It will be ON when a valid input
signal on Inputs A and B is present, and board power is good.
There are 7 small LEDs near the middle edge of the board that indicate the status of 7760VMS-HD.
GENLOCK PRESENT: This Green LED will be ON when the selected genlock input is present. It will be
OFF, if the genlock input is not present.
INPUT A PRESENT: This Green LED will be ON when there is a valid input signal present on module
input A. The LED will be OFF, if input signal is invalid or missing.
INPUT B PRESENT: This Green LED will be ON when there is a valid input signal present on module
input B. The LED will be OFF, if input signal is invalid or missing.
MODULE
push
OK
button
INPUT A
PRESENT
LOCAL
FAULT
GENLOCK
PRESENT
Figure 4-1: Status LED locations
7760VMS-HD HD Video Monitoring Splitter
1
2
3
INPUT B
AUDIO
Revision 0.3
7700 MultiFrame Manual
7760VMS-HD
4
Page - 7
Advertisement
Table of Contents
