Configuring Control Network Settings - evertz 7800 Manual

7800 MultiFrame Manual
7880DEC-H264HD H-264 HD Decoder
(1) Network Configuration
This sub-menu enables the user to configure the network settings for the card.
(2) SNMP Configuration
This sub-menu enables the user to configure the Simple Network Management Protocol settings. In this
menu you can set or remove the SNMP trap IP address and the SNMP Read and Set community
strings.
(3) Setup Decoder Parameters
This sub-menu is used to configure the decoder parameters. As this configuration can also be
performed via VLPro this sub-menu will not be covered in this section.
(4) Utilities
This sub-menu contains two utilities. One command is for clearing the memory, and the other for
clearing the flash. In normal operation it should not be necessary to use either of these options.
(5) Engineering/Debug
This menu is for Evertz personnel only. You may be requested to access and execute options within
this menu when seeking technical support from Evertz. Guidance will be given should this be required.
Before is it possible to configure the card via VLPro it is first necessary to configure the initial basic
network settings via the serial cable. Refer to section 2.3.
2.3.

CONFIGURING CONTROL NETWORK SETTINGS

To configure the network settings, select option (1) Network Configuration and the Network
Configuration menu will be displayed as shown in Figure 2-5. If you prefer to use DHCP then you may
select option (5) Use DHCP, and then continue from step 4:
1. Select option (1) Set IP Address and configure the IP address for the 7880DEC-H264HD
ensuring that the IP address is not already in use on the network.
2. Now select option (2) Set Netmask and configure the correct subnet mask for your network.
3. If required also configure option (3) Set Gateway.
4. Exit from the Network Configuration menu using (s) Save and Exit, NOT (x) Exit.
7880DEC-H264HD - 6
Revision 1.0