Table of Contents
Advertisement
3.
CARD CONFIGURATION
Right click the IP address of the 7880DEC-H264HD and select "View Configuration". The configuration
page will open; it is from these configuration tabs that the 7880DEC-H264HD can be configured. Refer
to the relevant section of this manual for an explanation of the features and functions.
3.1.
INPUT SELECT
The Input Select tab is used to select the input in use. Both inputs are bypass protected, thus in the
event of the card failing, being removed or the power being cut off, the loop-through for the ASI will
continue. The decoded output will no longer be available.
NOTE: If the card is removed from the chassis, the ASI loop through will continue
but the decoded output will no longer be available.
•
Decoder Input Select: The decoder card has two ASI inputs and one IP Input (IP input not
currently available EXP: Q2 2008). Using this option select the input you require.
NOTE: The decoder has two ASI inputs; the card is a single decoder and is only
able to decode one program from either of the two inputs.
Figure 3-1 VistaLINK
®
Revision 1.0
7800 MultiFrame Manual
7880DEC-H264HD H-264 HD Decoder
PRO – Input Select
7880DEC-H264HD - 9
Advertisement
Table of Contents
