Table of Contents
Advertisement
•
PID Display Mode: This field determines how the PID Monitor View displays the PID value.
Options are Hex or Decimal.
•
Clear All Stats: This parameter resets the statistics. Selecting the enable option and then the
Apply button will reset all of the statistics.
•
Clear All Errors: This parameter resets all of the error conditions. Select the enable option and
then the Apply button to reset all of the error conditions.
•
Input Source: Use the drop down menu to select the input source. The input source options are
IP or ASI.
•
Input IP Address: Enter here the destination IP address, the multicast address you want the
decoder to monitor. Ensure you enter the correct IP address and it is in the multicast address
range of 224.0.0.0 through 239.255.255.255.
•
Input Port Number: Enter here the destination port number for the IP address entered above.
•
VLAN Select: Use this drop down box to select the VLAN, configured from the main
configuration tab earlier, which contains the stream to be monitored. If you are not using VLANs
leave this set to "no vlan".
4.1.3. MDI Monitor
The MDI Monitor tab displays the MDI information.
•
Delay Factor: The Delay Factor is the maximum difference measured between the arrival of
each packet over a one second period. The value shown is measured in milliseconds and
represents the delay factor in the last second.
Figure 4-2: VistaLINK
Revision 1.0
7800 MultiFrame Manual
7880DEC-H264HD H-264 HD Decoder
PRO - MDI Monitor
®
7880DEC-H264HD - 21
Advertisement
Table of Contents
