Configuring The Basic Network Settings - evertz 7700 Manual

7700 MultiFrame Manual
7780DEC-MP2HD MPEG2 SD/HD Decoder
(5) Engineering/Debug
This menu is for Evertz personnel only. You may be requested to access and execute options within
this menu when seeking technical support from Evertz. Guidance will be given should this be required.
Before is it possible to configure the card via VLPro it is first necessary to configure the initial basic
network settings via the serial cable. Refer to section 2.2.
2.2.

CONFIGURING THE BASIC NETWORK SETTINGS

Now select option (1) Network Configuration, the Network Configuration menu will be displayed as
shown in Figure 2-5. If you prefer to use DHCP then you may select option (5) Use DHCP, and then
continue from step 4:
1. Select option (1) Set IP Address and configure the IP address for the 7780DEC-MP2HD
ensuring that the IP address is not already in use on the network.
2. Now select option (2) Set Netmask and configure the correct subnet mask for your network.
3. If required also configure option (3) Set Gateway.
4. Exit from the Network Configuration menu using (s) Save and Exit, NOT (x) Exit.
From the Main Menu select option (2) SNMP Configuration. Select option (1) Set IP Address and enter
the IP address of your VLPro Server. Exit using option (S) Save and Exit, now extract the card from the
rack, remove the serial cable and re-insert it.
You have now completed the necessary minimum configuration and can connect the cables to the rear
card when ready.
7780DEC-MP2HD - 10
Figure 2-5: Network Configuration Sub-Menu
Revision 1.1