Connecting To Vlpro; Figure 2-5: Network Configuration Sub-Menu - evertz 7800 Manual

5. From the Main Menu select option (2) SNMP Configuration and then select option (1) Set IP
Address. Enter the IP address of your VLPro Server.
6. Exit using option (S) Save and Exit option. Now extract the card from the rack, remove the serial
cable and re-insert it.
You have now completed the necessary minimum configuration and can connect the cables to the rear
card when ready.
2.4.

CONNECTING TO VLPRO

This chapter assumes that the VLPro server and VLPro client are already configured for your network
and you have basic knowledge of the VLPro interface. It also assumes that the user or network
administrator has already added the 7880DEC-H264HD jar file to the server and both the client and
server applications have been restarted. If you are the network administrator refer to section 6.2 for
information on updating the VLPro Server Jar File.
Open VLPro and click on the refresh tree icon. Expand the hardware tree by clicking on the "+" symbol.
Your 7880DEC-H264HD should appear as a newly listed device with the IP address used to configure
the card in Step 1 above. It may take up to a minute to appear while the card and switch negotiate
network settings (this can be verified directly on the switch if necessary).

Figure 2-5: Network Configuration Sub-Menu

Revision 1.0
7800 MultiFrame Manual
7880DEC-H264HD H-264 HD Decoder
7880DEC-H264HD - 7