Chassis Cleaning - Terex R190T Operation And Maintenance Manual

Coolant and machine components can be HOT! Allow the machine to
cool thoroughly prior to performing maintenance or service to avoid the
possibility of burns.

7.20 Chassis Cleaning

Procedure
Periodic cleaning of the chassis area
beneath the cab and engine com-
partment is also necessary to main-
tain safe operation. Clean as neces-
sary. (fig. 7.20-1)
To clean the chassis/engine:
1. Shut the machine down according to the procedure in section 5.13, then
remove the belly pans on the underside of the machine.
2. Raise the hood at the rear of the machine.
3. Pressure wash any debris from the engine compartment and chassis area
out through the lower opening.
4. Re-install the belly pans and close the hood to complete the cleaning
procedure.
If any safety signs are found to be damaged or missing after cleaning,
contact your dealer for a replacement immediately. They can be reap-
plied according to the location illustration in section 2.3 of this manual.
When using pressurized air or water for cleaning purposes, always wear
appropriate personal protection equipment to ensure your safety.
7.20-1
77
7 MAINTENANCE
R160T / R190T US O&M
0404-490 2014-06