Safety Signs (Ansi) - Terex R190T Operation And Maintenance Manual

2 SAFETY
2.3 ANSI Safety Sign Location
The safety signs are located in/on the machine as indicated. (Descriptions of the
symbols are provided in section 2.2)
2
Crush Hazard
Death or serious injury can result
from contact with moving lift arm or
attachment.
1
Fall Hazard
Use the provided access system when
Serious injury or death can result
entering or exiting the machine.
from falling.
2030-597
10
Crush Hazard
Death or serious injury can result
from contact with moving lift arm or
attachment.
Key
1. Fall hazard
2. Crush hazard (lift arms)
3. Skin (oil) injection hazard
4. Fire hazard (read manual)
5. Burn hazard
6. Explosion / burn hazard (read operator's manual)
7. Tie down location
8. Clean undercarriages notice
9. Crush hazard (run over)
10. Crush hazard (lift arm brace)
R160T / R190T US O&M
0404-490 2014-06
3
Escaping fluid under pressure can
penetrate skin, causing serious injury.
Keep clear of lift arms and
attachments.
2030-592
Install lift arm brace prior to servicing.
2030-594
• Relieve internal pressure before
disconnecting any line or fitting.
• Keep away from leaks or pinholes.
• Use cardboard to check for leaks.
Fluid injected into skin must be surgi-
Injection Hazard
cally removed within a few hours by a
doctor familiar with this type of injury
or gangrene will result.
2030-602
4
Read Operator's manual
Fire Hazard
Keep engine, exhaust and chassis
Flammable debris can collect near hot
areas free of debris.
components and lead to a fire.
9
CRUSH HAZARD
Contact with moving machine can Keep clear of moving machine.
result in death or serious injury.
2030-593
12
5
Allow the machine to cool thoroughly
Burn Hazard
before opening.
Hot fluid under pressure can scald.
2030-599
6
Explosion/Burn Hazard
Will cause death, burns or
blindness due to ignition of
explosive gasses or contact
with corrosive acid.
• Keep all flames/sparks
away!
• No Smoking!
• Read and understand
all manuals prior to
operation.
2030-603
7
8
NOTICE
Inspect undercarriages daily for
accumulation of debris. If debris
is present, clean thoroughly with
a pressure washer. If debris is
allowed to build up, it can cause
premature component wear and
decrease machine performance.
2085-253
2030-595