Chassis Cleaning - Terex TSV-70 Operation And Maintenance Manual

7 MAINTENANCE
Coolant and machine components can be HOT! Allow the machine to
cool thoroughly prior to performing maintenance or service to avoid the
possibility of burns.
7.15-1
7.16 Chassis/Engine Cleaning
Periodic cleaning of the chassis
area beneath the cab and engine
compartment is also necessary to
maintain safe operation. Clean as
necessary. (fig. 7.16-1)
To clean the chassis/engine:
1. Shut the machine down as described in section 5.13, allow the machine to
cool thoroughly, then remove the access panel on the underside of the
machine to allow drainage.
2. Open the rear door, then raise the hood and secure it.
3. Pressure wash any debris from the engine compartment out through the
lower opening. Once complete, close and latch the door and hood.
4. Tilt the cab as described in section 7.23.
5. Pressure wash any debris from the chassis area out through the lower
opening. Once complete, lower and secure the cab.
6. Re-secure the lower access panel to complete the cleaning procedure.
If any safety signs are found to be damaged or missing after cleaning,
contact your dealer for a replacement immediately. They can be reap-
plied according to the location illustration in section 2.3 of this manual.
1
7.15-2
7.16-1
76
2