Chassis Cleaning - Terex DTM 00101 (standard) Operation And Maintenance Manual

Coolant and machine components can be HOT! Allow the machine to
cool thoroughly prior to performing maintenance or service to avoid the
possibility of burns.
7.20-1
7.21 Chassis/Engine Cleaning
Periodic cleaning of the chassis area
beneath the cab and engine com-
partment is also necessary to main-
tain safe operation. Clean as neces-
sary. (fig. 7.21-1)
To clean the chassis/engine:
1. Shut the machine down as described in section 5.13, allow the machine to
cool thoroughly, then lower the belly pans on the underside of the machine.
2. Remove the intake precleaner, then raise the hood at the rear of the
machine.
3. Pressure wash any debris from the engine compartment out through the
lower opening. Once complete, close and latch the hood.
4. Tilt the cab as described in section 7.24.
5. Pressure wash any debris from the chassis area out through the lower
opening. Once complete, lower and secure the cab.
6. Re-secure the belly pans and reinstall the precleaner assembly to complete
the cleaning procedure.
If any safety signs are found to be damaged or missing after cleaning,
contact your dealer for a replacement immediately. They can be reap-
plied according to the location illustration in section 2.4 of this manual.
1
7.20-2
7.21-1
91
7 MAINTENANCE
2