Esc 3 N; Esc - Epson TM-H5000II Series Manual

CONFIDENTIAL

ESC 3 n

[Name] Set line spacing
[Format] ASCII
Hex
Decimal
0 £ n £ 255
[Range]
[Description] Sets the line spacing to [ n ´ vertical or horizontal motion unit] inches.
· The line spacing is set to the paper selected by ESC c 1.
[Notes]
· The line spacing can be set independently in standard mode and in page mode.
· The horizontal and vertical motion unit are specified by GS P. Changing the
horizontal or vertical motion unit does not affect the current line spacing.
· The GS P command can change the horizontal (and vertical) motion unit.
However, the value cannot be less than the minimum vertical movement
amount, and it must be in even units of the minimum vertical movement
amount.
· In standard mode, the vertical motion unit (y) is used.
· In page mode, this command functions as follows, depending on the starting
position of the printable area:
· The maximum paper feed amount is 1016 mm (40 inches). Even if a paper
feed amount of more than 1016 mm (40 inches) is set, the printer feeds the
paper only 1016 mm (40 inches).
[Default] Line spacing equivalent to approximately 4.23 mm (1/6 inches).
[Reference] ESC 2, ESC c 1, GS P
ESC <
[Name] Return home
[Format] ASCII
Hex
Decimal
[Description] Moves the print head to the standby position.
· This command is available only when slip paper is selected.
[Notes]
· Since the home position is detected when this command is executed, the
printing position may shift after this command is executed.
· The standby position is in the left.

ESC

3
1B 33
27 51
When the starting position is set to the upper left or lower right of the
printable area using ESC T, the vertical motion unit (y) is used.
When the starting position is set to the upper right or lower left of the print
able area using ESC T, the horizontal motion unit ( x ) is used.
ESC <
1B 3C
27 60
TITLE
TM-H5000 II II II II series
Specification
(STANDARD)
n
n
n
NO.
SHEET
REVISION
NEXT
E
SHEET
111
112