Printing And Cutting Positions; General Section (For Both Receipt And Slip); Internal Buffer - Epson TM-H5000II Series Manual

CONFIDENTIAL

1.2.7 Printing and Cutting Positions

Manual-cutter position
Auto-cutter blade position
Center of the print dotline
NOTE: Numeric values used here are typical values; the values may vary slightly as a result
of paper slack or variations in the paper. Take the notice into account when setting
the cutting position of the auto-cutter.

1.3 General Section (for both receipt and slip)

1.3.1 Internal Buffer

1) Receive buffer selectable as 45 or 4K bytes using the DIP switch.
2) User-defined buffer (both for user-defined characters and user-defined bit images)
Receipt : 12K bytes Slip: 3K bytes
3) Macro buffer 2K bytes
4) NV (non-volatile) bit image buffer 384K bytes
5) User NV (non-volatile) memory 1K byte
Figure 1.2.3 Printing and Cutting Positions
TITLE
TM-H5000 II II II II series
Specification
(STANDARD)
Approx. 29
26.3
14.8
Approx. 15
Paper feed direction
[ Units: mm (All the numeric values are typical.) ]
NO.
SHEET
REVISION
NEXT
E
SHEET
14
15