Epson TM-H5000II Series Manual page 112

CONFIDENTIAL
· DLE ENQ 2 enables the printer to recover from an error after clearing the data
in the receive buffer and the print buffer. The printer retains the settings (by
ESC !, ESC 3, etc.) that were in effect when the error occurred. The printer can
be initialized completely by using this command and ESC @. This command is
enabled only for errors that have the possibility of recovery, except for print
head temperature error.
· When the printer recovers from an error using DLE ENQ 2 with slip selected,
the printer ejects the slip completely and selects the paper roll. Therefore,
when printing on slip is to be continued, select slip mode again using
ESC c 0 4 after the slip is ejected.
· DLE ENQ 3 is ignored except when the printer is in the slip waiting state.
Therefore, be sure to use DLE EOT 5 to check whether slip paper is selected
and the printer is in the slip waiting state before executing DLE ENQ 3. After
the printer is released from the slip waiting state, the printer selects the paper
roll.
· When the slip waiting status is cancelled DLE ENQ 3, the receive and print
buffers are cleared.
· When the printer is disabled with ESC = (Select peripheral device), the error
recovery functions (DLE ENQ 1 and DLE ENQ 2) are enabled, and the other
functions are disabled.
[Reference] DLE EOT
TITLE
TM-H5000 II II II II series
Specification
(STANDARD)
NO.
SHEET
REVISION
NEXT
E
100
SHEET
99