Epson TM-H5000II Series Manual page 164

CONFIDENTIAL
GS ( A p p n m
L H
[Name] Execute test print
[Format] ASCII
Hex
Decimal
[Range] ( p +( p
L
0 £ n £ 4, 48 £ n £ 52
1 £ m £ 3, 49 £ m £ 51
[Description] · Executes a test print with a specified test pattern on a specified paper.
· p
L
256)) bytes.
n specifies the paper to be tested.
m specifies a test pattern.
[Description] · This command is enabled only when processed at the beginning of a line in
standard mode.
· This command is no effect in page mode.
· When this command is received during macro definition, the printer ends macro
definition and begins performing this command.
· After the test print is finished, the printer resets itself automatically. Therefore,
the already-defined data before this command is executed, such as an user-
defined characters, downloaded bit image, and macro, becomes undefined,
and the receive buffer and print buffer are cleared, and each setting returns to
the default value. The printer also re-reads the DIP switch settings .
· At the end of the test print, the printer cuts the paper, or ejects the cut sheet
when the cut sheet is selected.
· When the cut sheet is selected, this command is executed after the ejection of
the paper if the paper is ejected currently.
· The printer goes BUSY while this command is executed.
GS ( A
1D 28 41
29 40 65
´256))=2
(where p
H L
and p specifies the number of the parameter such as n , m to ( p
H
n Paper
0, 48 Basic sheet (paper roll)
1, 49
Paper roll
2, 50
3, 51
Slip
4, 52
m Test pattern
1, 49 Hexadecimal dump
2, 50 Printer status print
3, 51 Rolling pattern print
TITLE
TM-H5000 II II II II series
Specification
(STANDARD)
pL pH n m
pL pH n m
pL pH n m
=2, p =0)
H
SHEET
REVISION
E
´
+ ( p
L H
NO.
SHEET
NEXT
151
152