Epson TM-H5000II Series Manual page 93

CONFIDENTIAL
Example
When printing a downloaded bit image of six bytes in the vertical direction, use the following
formula:
{number of vertical dots (8 ´ 6) - number of dots for feeding at the beginning of the printable
area (21)} ´ vertical motion unit conversions (360/180) = 54
Therefore, 27 dots (54 pitch) are required for feeding.
Use the following commands:
ESC W x , x
L
ESC T n
ESC 3 54 ¬ Set line spacing to be added.
LF
GS/ 1
ESC 2 ¬ Reset the line spacing to 1/6 inch.
NOTE: Vertical and horizontal motion units are 1/360 in the vertical direction and 1/180 in the
horizontal direction; therefore, the position you specify varies depending on the
printing direction. Setting the vertical motion unit to 1/180 using the GS P command
does not change the current print position.
(x0, y0)
Point A
, y , y , dx , dx , dy
H L H L H L
Development direction
Base line
Printing area
Figure 3.12.2 Character Data Developing Position
TITLE
TM-H5000 II II II II series
Specification
(STANDARD)
, dy
H
[Units: dots]
SHEET
REVISION
E
(dx, dy)
NO.
SHEET
NEXT
80
81