Figure 2-8 Pull The Wires Out The Bottom Of The Positioner; Figure 2-9 Secure The Gasket And Removable Plug To The Bottom Egress - Will Burt PositionIt PI-35 Operator's Manual

7. Pull the wires still in the positioner through the hole at the side egress.
8. Reconnect the quick connect between the wires from the positioner and the plug making
sure the gasket is in place.
9. Gently push the wires into the positioner and secure the gasket and removable plug in
place at the bottom of the mounting pedestal (Figure 2-9). Apply silicone sealant or
equivalent to the screws. If the gasket is not properly installed, the positioner will leak
and become damaged voiding the warranty.

Figure 2-9 Secure the Gasket and Removable Plug to the Bottom Egress

TP-5406201-B
July 2017

Figure 2-8 Pull the Wires out the Bottom of the Positioner

I PI-35
OSITION T
P
2-7