Next, use the provided plywood board as a ramp by first placing it in position as shown in Figure 5.
Then secure the ramp to the skid using the provided nails. There are pre-drilled holes in the plywood
board, indicated by red circles.
Make sure the casters are not locked and very carefully roll the machine down the ramp (Figure 6).
BE SURE TO USE 2 PEOPLE TO DO THIS SAFELY!
The CHAMP 150 may now be rolled into its final position. Replace the lower front cover.
F.150CH-O-A
Figure 5
Figure 6
Page 11
5.0 Installation & Setup
June 2023