Challenge CHAMP 150 Operator's Manual page 10

5.0 Installation & Setup
Remove the 4 lag screws from the top of the board stacks, and also the 3 lag screws located at the
front of the skid, as indicated in Figure 3Figure 4.
Carefully lean the CHAMP 150 forward slightly while having a second person pull out the two boards
located at the top of the board stack from the rear side of the CHAMP 150, as shown in Figure 4.
Now lean the CHAMP 150 rearward slightly and repeat the procedure for the top two boards at the
front side of the machine.
F.150CH-O-A
Figure 3
Figure 4
Page 10 June 2023