Installation & Setup; Inspecting Shipment; Uncrating - Challenge CHAMP 150 Operator's Manual

Hide thumbs Also See for CHAMP 150:

Table of Contents

5.0 Installation & Setup

This machine has been carefully packed to prevent damage during shipment. However, claims for

damage or loss are the responsibility of the recipient. Inspect all shipments as soon as they are

received. If there is any noticeable damage, note it on the freight bill. Visual and/or hidden damage

must be reported to the claims department of the carrier within 15 days. Contact your dealer if you

need any assistance. Check the contents of the box against the packing list on page 7. Make sure

there are no missing items.

The CHAMP 150 weighs approximately 600 lb (270kg). DO NOT risk personal injury or damage by

attempting to move machinery with makeshift equipment or inadequate manpower. This machine is

shipped on a wooden skid and enclosed in a protective, corrugated top. The skid is designed to allow

the machine to be rolled off without any special lifting equipment. The machine is held in place by

two, 2x4 braces lag bolted to the skid. All accessories are shipped inside of the machine.

Remove the carton by removing the nails or staples holding it to the skid and lift it straight up over the

cutter. If you don't have the ceiling clearance to do this, carefully slit the carton down the side and

then unwrap it from around the cutter.

Remove the plywood "ramp" and set it aside for now. Also remove any accessories and set them

aside.

Remove the lower front cover from the CHAMP 150. Then remove the four lag screws that hold the

CHAMP 150 to the skid, as indicated in Figure 2.

Figure 2

F.150CH-O-A

Page 9

June 2023

Table of Contents