6.0 Operation
6.0 Operation
IMPORTANT: DO NOT ATTEMPT TO OPERATE THE CHAMP 150
UNTIL YOU HAVE THOROUGHLY READ AND UNDERSTAND ALL OF THE FOLLOWING
INSTRUCTIONS. CALL YOUR AUTHORIZED CHALLENGE DEALER IF YOU STILL HAVE ANY
QUESTIONS.
6.1 Console Controls
The console controls consist of a main power switch, inch/mm selector, and knife adjust switch, and
cut/clamp buttons.
Figure 9 – Main Console
6.2 Power – Main Switch
Figure 10 – Main Power Switch
Power is turned on to the machine by switching the main power switch to the "ON" position. The
display and line light are turned on at this time. The hydraulic motor will not be activated until a cut
cycle is initiated, and it will shut off after the completion of the cut cycle.
F.150CH-O-A
Page 14
June 2023