Installing Air Lift Performance 3H/3P Kit
LAYOUT OVERVIEW
NOTE
For a complete installation diagram, see Pages 16-17. See Page 2 for a complete parts list.
Layout
1. Plan component location first. Ideally, the manifold should be located at a level above
2. Prior to mounting components, check to make sure:
NOTE
Be sure to install all components as far as possible from any heat sources (figs. 2 and 3).
Plan and prepare harness and air line routing thru the vehicle. Eliminate all sharp edges that
could chafe. Use rubber grommets when passing through compartment walls.
4
the compressor and tank to avoid compressor ingested water from gathering in the
manifold (fig. 1). This is most important for vehicles operated in below-freezing climates.
•
the electrical harness connections will reach the manifold and compressor.
•
the compressor leader hose will reach the tank.
•
the air lines will route cleanly through the vehicle without kinking or bending.
COMPRESSOR
fig. 2
MANIFOLD
AIR TANK
Installation Manual
fig. 1
fig. 3
MN-946