System Messages - Air Lift 27691 Instruction Manual

System Messages

Label
NOTICE
Calibration not completed Customer attempts to use presets prior to calibration.
Manifold upside down,
NOTICE
please re-mount
Leak detected on corner
CAUTION
(FL, FR, RL, RR*)
Check height wiring and
CAUTION
plumbing (FL, FR, RL,
RR*)
CAUTION
Waiting for tank to fill
Height sensor failure
DANGER
(FL, FR, RL, RR*)
CAUTION
Range fault
CAUTION
Limit reached
CAUTION
Min drive height reached
CAUTION
Low battery voltage
CAUTION
High battery voltage
Pressure sensor failure
DANGER
(FL, FR, RL, RR*)
Pressure preset mode
CAUTION
disabled
Corner height sensor
DANGER
failure (FL, FR, RL, RR*)
* FL = Front left corner
FR = Front right corner
RL = Rear left corner
RR = Rear right corner
20
Fault
The manifold has been mounted in an unacceptable
orientation.
A leak has been detected between manifold and the air
spring that is causing a drop in air pressure.
The system has detected that the either the wiring is
incorrect or not responding or lines are plumbed incorrectly
for the given corner.
Detected that tank pressure dropped 15 PSI below user
defined max tank pressure value.
Detected that sensor signal has gone invalid or out of range
for the given corner.
Height sensor range is too low to provide accurate data to
the user and will need to be adjusted to provide adequate
sensor travel.
Height sensor travel is out of acceptable range of 10-90%
of full sensor travel. Re-adjust sensor to be in range of
acceptable wheel travel.
The system has detected vehicle is moving and therefore
prevented vehicle from going below minimum drive height.
Vehicle has reached the user defined set value for minimum
battery voltage used for disabling the compressor.
Vehicle has detected battery voltage above 16V.
Detected a pressure sensor failure at the manifold block for
the corner sensor.
System has detected a failure in the pressure sensor and
disabled pressure preset. Can still operate height preset if
installed.
Corner height sensor voltage is out of range.
3H/3P User Guide
Problem
MN-948