Air Lift 27691 Instruction Manual page 53

3H/3P User Guide
Calibration Detail Explained, Cont.
HEIGHT
Below is what the wizard is doing during height calibration.
The system will actuate suspension through it's entire height range
to calibrate height mode.
1. Movement calibration
● A message will indicate completion of the movement
calibration.
● Press the middle button to continue.
2. At any time, cancel calibration by pressing "stop."
MANIFOLD
Below is what the wizard is doing during manifold calibration.
1. If the manifold is mounted correctly, it will indicate "Complete –
calibration successful."
2. If the manifold is mounted incorrectly, it will indicate "Fault –
calibration failed."
3. If mounted incorrectly, follow the Installation Guide for proper
mounting of the manifold and run calibration again.
MN-948
15