Air Lift 27691 Instruction Manual page 48

Setup
SENSOR TOOL (HEIGHT MODE
MUST BE ENABLED)
This tool is used to ensure that the range of
the height sensors as installed are sufficient
to provide optimal accuracy for the system.
(Each time that this tool is used it will reset and
initially show low range until the suspension is
cycled to tell the system its range.)
1. At any time press the "Preset Ride" button
to exit the tool.
2. By cycling the suspension up and down,
the tool will determine the following:
• Range low – Not enough range in the
sensor to portray accurate data.
• OK – The range of the sensor is
adequate for accurate data.
• Limit – The range of the sensor is at or
beyond the bounds of acceptable data.
COMPRESSOR* (SETUP)
ON/OFF
Control the compressor manually. In the
default setting of "Off" the compressor will
operate normally. Selecting "On" will activate
the compressor for troubleshooting.
1. Off (default)
2. On
ENABLE/DISABLE
Enable or disable the compressor until the next
ignition cycle.
1. Enabled (default)
2. Disabled
* The 3H/3P system can be installed with one or two compressors.
10
3H/3P User Guide
MN-948