Air Lift 27691 Instruction Manual page 19

Installation Manual
LINKAGE ASSEMBLY/MODIFICATION
1. Locate the linkage and ensure the rod is threaded all the way on (fig. 22).
2. Next put the suspension in the mid-position with respect to full suspension travel (fig. 23).
3. Fasten by finger tightening the linkage to the sensor arm and ensure the sensor arm
4. Loosen if needed in order to extend to reach the lower mounting point. If loosening the
5. If shortening the rod linkage is necessary, mark the rod cover where the mounting
MN-946
Thread both ends all the way down
is at mid-position with respect to the sensor (fig. 24).
linkage to extend it is required, make sure to have at least 5 threads of engagement
on both ends (fig. 25).
location intersects with the intended mounting location (fig. 26).
Mid-position
Min.
Max.
Minimum 5 threads
engaged
Mark here
CONTINUED ON PAGE 18
fig. 22
fig. 23
fig. 24
fig. 25
fig. 26
15