Air Lift 27691 Instruction Manual page 50

Calibration
WIZARD
Run this program to complete calibration. At any
time, cancel calibration by pressing "stop."
1. Make sure the vehicle is on a level surface
and select "Yes."
2. Verify that the front wheels are straight to
prevent damage to fenders, then select
"Yes."
3. Verify nothing is under the vehicle that
could cause undercarriage damage, then
select "Yes."
4. Verify that the manifold is securely
mounted, then select "Yes."
NOTE
An unmounted manifold will not allow
Preset Maintain to function properly.
5. Determine how many compressors are in
use. If using a single compressor, select
one. If using two compressors with the
second compressor harness (part number: 27703) select
two.
6. If height sensors are installed, select "Yes." If running as a
pressure only system, select "No." If only running pressure,
system will now skip to step 8.
7. If height sensors are installed, select whether to calibrate
them automatically or manually. Most vehicles can be
calibrated automatically. The manual option can be used
when there is a custom setup where there may be concern
about component interference at either high or low limits.
8. After selecting "Yes" the system will begin calibration.
Selecting "No" will exit the calibration wizard.
9. System checks to make sure manifold is mounted in a
proper orientation.
10. System is calibrating the accelerometer.
11. System is now calibrating the front axle for Pressure mode.
12. System is now calibrating the rear axle for Pressure mode.
If using the system for Pressure only, calibration will
complete after this step.
12
3H/3P User Guide
MN-948