Selection Of Terminal Functions; Changing Input Terminal Functions; Keeping An Input Terminal Function Always Active (On); Signal On Completion Of Acceleration/Deceleration (Out) - Toshiba TOSVERT VF-P7 Instruction Manual

6.3 Selection of terminal functions

6.3.1 Keeping an input terminal function always active (ON)

 ：Always active function selection
・Function
This parameter is used to select a function to be kept always active (ON) from among the
input terminal functions. (One function can be selected)
■Parameter setting
Title

※The selected function is kept always active regardless of the type of logic (positive or negative) in the
table of function settings in 7.2.1.

6.3.2 Changing input terminal functions

 ：
Input terminal selection #1 (F)
 ：
Input terminal selection #2 (R)
 ：
Input terminal selection #3 (ST)
 ：
Input terminal selection #4 (RES)
 ：
Input terminal selection #5 (S1)
Refer to 7.2.1 for details.
6.3.3 Signal on completion of acceleration/deceleration (OUT 2)
 ：Output terminal selection #2 (OUT2)
・Function
If this parameter is so set, a signal is put out on completion of acceleration/deceleration.
★Open collector output terminal OUT1 or OUT2 (24 Vdc - max. 50 mA)
■Setting of output terminal
Title

OUT1 for putting out a signal, select the parameter
Note)
Output frequency [Hz]

(Speed reach detection band)
Acc. Completed(a-contact)
(
Acc. Completed(b-contact)
Function
Always active function selection ∼
Function
Output terminal
selection #2 (OUT2)
Reference
０
Adjustment range
 ：
Input terminal selection #6 (S2)
 ：
Input terminal selection #7 (S3)
 ：
Input terminal selection #8 (S4)
 ∼  ：
Adjustment range
∼
F-7
Default setting

Input terminal selection #9∼#16
Setting value
: Acceleration/deceleration
completion(a-contact)
or
: Acceleration/deceleration
completion(b-contact)
.
[s]
ON
OFF
)
ON
OFF