Toshiba TOSVERT VF-P7 Instruction Manual page 175

Parameter setting
Positive Negative Function
logic logic
92 93 Designated data output #1
94 95 Designated data output #2
96 97 Designated data output #3
98 99 Designated data output #4
100 101 Designated data output #5
102 103 Designated data output #6
104 105 Designated data output #7
106 107 Light load signal
108 109 Heavy load signal
110 111 Positive torque limit
112 113 Negative torque limit
Output for external rush
114 115
suppression relay
116 117 Over travel
118 119 Completion of positioning "ON": Positioning has been completed.
Note 1: "ON" in positive logic:
"OFF" in positive logic:
"ON" in negative logic:
"OFF" in negative logic: Open collector output transistor or relay is turned on.
Note 2: Alarm output check conditions are as follows.
1) Under-voltage detected: To be checked during operation.
2) Low current detected:
3) Over-torque detected:
■Sink logic/source logic
Sink logic and source logic (input/output terminal logic) can be switched to each other.
Refer to the section 2.3.2
Operation output specifications (in case of positive logic)
Output of the designated data in 7 bits.
"ON": Load is equal to ∼(Heavy load torque) set
values or less.
"ON": Load is larger than ∼ set value.
"ON": Positive torque is over the positive torque limit level.
"ON": Negative torque is over the negative torque limit level.
"ON": External rush suppression relay is actuated.
"ON": Over running
Open collector output transistor or relay is turned on.
Open collector output transistor or relay is turned off.
Open collector output transistor or relay is turned off.
To be checked during operation command.
To be checked always.
G-8