Selecting An Operation Mode - Toshiba TOSVERT VF-P7 Instruction Manual

5.3 Selecting an operation mode

 : Operation command mode selection
 : Speed setting mode selection
･ Function
These parameters are to select the operation command from among the operating panel,
the terminal board, a communication device and other optional control devices, to which
priority should be given when start, stop or frequency reference are issued by them.
[Parameter setting]
Title
Operation command

mode selection
[Set value]
Terminal operation
:
Start and stop control is exercised by means of external signals.
peration panel
: O
Start and stop control is exercised by pressing the
(Including start and stop control from an extended panel (optional))
Communication common serial optional
:
Start and stop control is exercised from an RS232C device (optional) and a RS485
(optional).
RS485 communication(standard)
:
Start and stop control is exercised from RS485 communication device fitted as standard.
Communication option
:
Start and stop control is exercised from add-on module communication option.
[Parameter setting]
Title
Speed setting mode

selection
Function
: Terminal block enabled
: Operating panel enabled
: Common serial communication option enabled
: Serial communication RS485 enabled
: Communication add-on cassette option enabled
Function
: VI (voltage input)/II (current input)
: RR (volume/voltage input)
: RX (voltage input)
: RX2 (voltage input) (optional)
: Operating panel input
: Binary/BCD input(optional)
: Common serial communication option(FA01)
: Serial communication RS485(FA05)
: Communication add-on cassette option(FA07)
: Up-down frequency
: Pulse input #1 (optional)
Adjustment range
or
RUN
Adjustment range
E-6
Default setting

key on the control panel.
STOP
Default setting
