Toshiba TOSVERT VF-P7 Instruction Manual page 70

1) Setting the start, stop and operation frequencies with the operating panel
Title Function
Operation command

Mode selection
Speed setting mode

selection
R/L1
Power
S/L2
supply
T/L3
G/E
CC
2) To set the start and stop frequencies (forward run, reverse run and free-run stop) by
means of external signals and to set the operation frequency with the control panel
Title Function
Operation command

Mode selection
Speed setting mode

selection
R/L1
Power
S/L2
T/L3
supply
G/E
CC
Set value
(operating panel)
(operating panel)
Moto
U/T1
IM
V/T2
W/T3
F
R
Control panel
ST
The inverter is shipped with
these terminals shorted.
CC
RX VI II RR PP
Set value
(Terminal input)
(operating panel)
Moto
U/T1
IM
V/T2
W/T3
Forward run if ON
F
Slowdown stop if OFF
Reverse run if ON
R
Control panel Slowdown stop if OFF
ST
Standby if ON,
Coast stop if OFF
CC
RX VI II RR PP
E-8
[Start/stop]: Press the key on the control
RUN
panel.
☆To switch between forward run and reverse run, use
the forward/reverse run selection parameter .
[Frequency ref.]: Set the frequency, using the
key on the operating panel.
▲ ▼
r
To save the frequency, press
the Enter key.
and the set frequency are
displayed alternately for a
while.
[Start/stop]: Connection and disconnection of terminals
F-CC/R-CC (Standby: connection of
terminals ST and CC)
[Speed command]: Set the frequency, using the
▲ ▼
★As for the action the motor
r
★ To save the frequency,
STOP
Then, 
key on the control panel.
takes when both
terminals F and R
connected at the same time,
you can make selection
between reverse run and a
stop. => Refer to 6.2.2.
press the Enter key. Then,
 and the set frequency
are displayed alternately for
a while.
the
are