Seat Installation - Champion Phlebotomy Sprit BDC Owner's Operating And Maintenance Manual

SEAT INSTALLATION

WARNING
1. Position Chair Frame in upright position. Check tightness of all installed screws, bolts, nuts and other
fasteners in case they loosened during shipping.
2. Align the mounting holes on the plastic Seat with the Seat Support holes. Hole spacing of Seat and Seat
Supports will be narrower toward front of chair. Seat can only be installed facing one direction (FIG. 1).
3. Using the included wrench (or your own 5/ 1 6" tool), install the four (4) included Seat Screws through the
holes of Chair Frame, and into the four (4) holes on bottom of the plastic Seat. Make sure screws are
completely tightened (FIG. 1).
NOTE: These "special" screws MUST BE USED for maximum grip in this seating application. They can be
slightly difficult to "get started" in the holes on the plastic Seat.
TIP: Use even pressure and, if available, a "5/ 1 6" nut-driver" (screwdriver-type handle with a 5/ 1 6" socket on end)
however, this task can be accomplished with the included wrench.
Page 9 of 30
manual
Document No.: 006020 - Revision: R
Failure to completely tighten the seat mounting screws COULD RESULT IN SERIOUS
INJURY.
FIG. 1