Page 2
Champion assumes no responsibility for damage or injury caused by improper assembly, instal- lation, use, or maintenance of these products. No part of this manual may be duplicated in any form without the prior consent of Champion Manufacturing, Inc . Unauthorized duplication/distribution of these materials may result in civil prosecution to the maximum extent allowed by law.
TABLE OF CONTENTS Important Safety Information ..................... 4 Transportation, Storage, Handling & Disposal ................ 4 505 Task Chair without Armrests ....................5 506 Task Chair with Adjustable Armrests .................. 5 Base Assembly ......................... 5 Back Assembly ......................... 5 Arm Installation for 506 Model Only ..................6 Operation of Task Chair ......................
• The product should be stored in an environment that will inhibit rust/mold formation. • Champion Manufacturing, Inc recommends not leaving the product in the factory packing in excess of three (3) months. • The product should always be handled in a manner consistent with the user instructions and in a manner to prevent contamination after each use.
505 TASK CHAIR WITHOUT ARMRESTS FIG. 1 506 TASK CHAIR WITH ADJUSTABLE ARMRESTS BASE ASSEMBLY 1. Place the 5-Star Chair Base on a clean, flat surface with wheels down. FIG. 2 2. Push the large end of the Gas Cylinder into the center hole of the 5-Star Chair Base.
ARM INSTALLATION FOR 506 MODEL ONLY 7. Remove the Arm Support Adjustment Knob and Hardware from the Adjustable Armrest. 8. Slide the Adjustable Armrest into the Armrest Bracket located under each side of the Upholstered Seat. Secure the Adjustable Armrest by installing the Arm Support Adjustment Knob and Hardware through FIG.
Page 7
If your Champion task chair did not come with the HR Caster option, and you would like to add them, please contact Champion Mfg. for pricing and assembly instructions. Championchair.com (352) 854-2929.
507 GAS-LIFT TASK SEATING FIG. 1 4300 4308 4350 4358 4400 4408 4450 4458 GAS-LIFT TASK SEATING BASE ASSEMBLY 1. Place the 5-Star Chair Base (black plastic or chrome) on a clean, flat surface with bottom facing up (Fig. 1). FIG.
If your Champion task chair did not come with the HR Caster option, and you would like to add them, please contact Champion Mfg. for pricing and assembly instructions. Championchair.com (352) 854-2929.
Periodically inspect tightness of all screws, bolts, nuts, or other fasteners. Champion furnishings are built to provide durable reliable service when properly cared for. In general all of our products should be: 1) Cleaned, 2) Rinsed and 3) Allowed to air dry. It is important to note that disinfecting a product is not the same as cleaning the product.
IMPORTANT: ALWAYS REFER TO THE WEIGHT CAPACITY LABEL ON YOUR CHAIR. In all cases the labeling on the chair at the time of delivery indicates the correct rating for your chair – Weight rating should not be exceeded! SPECIFICATIONS Task Stools Min.
Page 12
We reserve the right to add or delete products at any time and without prior notice. Always provide your product's specific serial number when ordering any replacement parts. When in doubt, contact a Champion representative (352-854-2929 or 1-800-237-3377) for further information.
Page 13
Information contained in this document is based on the latest product data available at the time of printing. Photography, artwork, text and specifications are subject to change. Photographs may show optional items. Champion Manufacturing Inc. reserves the right to make changes to products, materials, options, and/or specification at any time without notice or obligation. Always provide your product's specific serial number when ordering replacement parts.