Table of Contents
Advertisement
ARM ASSEMBLY AND INSTALLATION
1. If the Arm Assembly has not yet been installed, insert it into the Receiving Tube on the Seat Frame
Assembly (FIG. 1). This applies to any style arm assembly.
ALWAYS make sure that the slot in the Arm Assembly faces the Knob installed on the receiving tube
•
(FIG. 1).
2. Then adjust the arm to the desired height and tighten the knob. Screw the Knob into the Slot. This will
"capture" the arm and keep it from being able to be pulled out of the frame accidentally.
IMPORTANT: DO NOT OVER-TIGHTEN. The Knob will NOT need to be extremely tight to effectively hold
arms in position.
Page 24 of 30
manual
Document No.: 006020 - Revision: R
FIG. 1
Advertisement
Table of Contents
