Pivot Arm Pivot-Point Adjustment - Champion Phlebotomy Sprit BDC Owner's Operating And Maintenance Manual

PIVOT ARM PIVOT-POINT ADJUSTMENT

Your Pivot Arm Assembly may be configured in one of two (2)
directions:
• Pivot point located near the back of the chair. This will
provide arm support that is straight or at a slight angle
to the side of the patient (standard position) (FIG. A).
• Pivot point located near front of chair. This will provide
arm support across the front of the patient's body.
1. If you wish to change the standard setup of the Pivot Arm
(FIG. 1) so that the pivot point is toward the front of the
chair, proceed to the next step. Otherwise, skip this step. If
you ordered Dual Pivot Arms, you can choose which Arm(s),
if any, you wish to alter. This change may be made before or
after Arm Assembly is installed on the chair.
2. Use a Phillips or #2 square bit screwdriver to remove the
four (4) wood screws on the underside of the arm assembly
that hold the pivot arm assembly onto the steel arm support.
3. After removing the four (4) wood screws, rotate the steel arm support 180° (FIG. 2).
4. Reinstall the four (4) wood screws to secure the arm support in the new position (FIG. 3).
FIG. 1
Page 28 of 30
manual
Document No.: 006020 - Revision: R
FIG. 2 FIG. 3