BORETTI CFBG902AN2 Instruction On Mounting And Use Manual page 44

Assembly and dismantling of the side runner frames
* Fit the side runner frames into the holes on the side walls inside the oven
(fig. 7.6).
* Slide into the guides, the shelf and the tray (fig. 7.7).
* The rack must be fitted so that the safety notch, which stops it sliding out,
faces the inside of the oven; the guard rail shall be at the back.
To dismantle, operate in reverse order.
Telescopic sliding shelf supports (fig. 7.8)
The telescopic sliding shelf support makes it safer and easier to insert and
remove the oven shelf. It stops when it is pulled out to the maximum position.
Important
When installing the sliding shelf support, make sure that:
* You fit the RH and LH sliding guides on the wire support (fig. 7.9).
* You press the RH and LH sliding guides against the fixing wires
(fig. 7.10). You will hear a click as the safety locks clip over the wire.
* You fit the oven shelf above the sliding shelf support (figs. 7.11, 7.8).
* You slide, on the guides inside the oven cavity, the sliding shelf support with
the oven shelf fitted above:
– the oven shelf shall run out towards the oven door;
– do not use the top shelf position;
– the short bend on the wire support shall face the inside of the
oven;
– the oven shelf must be fitted so that the guard rail faces the
inside of the oven.
42