Lighting The Burners - BORETTI CFBG902AN2 Instruction On Mounting And Use Manual

Lighting the burners

To ignite the burner, the following instructions are to be followed:
1. Press in the corresponding knob and turn counter-clockwise (fig. 3.2) to the
full flame position marked by
il the flame has been lit. In the case of a mains failure light the burner with a
match or lighted taper.
2. Wait for a few seconds after the gas burner has been lit before letting go of
the knob (valve activation delay).
3. Adjust the gas valve to the desired position. If the burner flame should go
out for some reason, the safety valve will automatically stop the gas flow.
To re-light the burner, return the knob to the closed " " position, wait for
at least 1 minute and then repeat the lighting procedure. If your local gas
supply makes it difficult to light the burner with the knob set to maximum,
set the knob to minimum and repeat the operation.
Dual burner - some models only
* The Dual Burner is a very flexible burner which allows different regulations and
optimal cooking. It is composed by one inner and one outer crown: the inner
and outer crown can be used together or separately.
The Dual burner is controlled by two separate knobs:
* one knob for the inner crown only ("
* one knob for the outer crown only ("
The Dual burner can be used:
* as a small burner (flame produced only by the inner crown);
* as a Ultra-rapid burner (flame produced only by the outer crown);
* as a high-power burner (all flames produced simultaneously by inner and
outer crown).
Important:
After using the dual burner check both the control knobs are in the closed
" " position.
the symbol (fig. 3.1); hold the knob in unt
" symbol identifying the control knob);
" symbol identifying the control knob).
15