BORETTI CFBG902AN2 Instruction On Mounting And Use Manual page 36

2. Set the end of the cooking time by pressing the
already added to the clock time will appear), and the
you pass the desired time you may get back by pushing the
After this setting, the
flashes on the display and a buzzer sounds, it means there was an error in
the programming, that is that the cooking cycle has been superimposed on
the clock. In this case, modify the end of cooking time or the cooking period
itself by following again the above mentioned instructions.
3. Set the temperature and the cooking program by using the switch and
thermostat knobs of the oven (see specific chapters).
Now the oven is programmed and everything will work automatically,
that is the oven will turn on at the right moment to end the cooking at the
established hour. During cooking, the
By pushing the button you can see the time that remains until the end
of cooking.
The cooking program may be cancelled at any time by pushing
At the end of the cooking time the oven will turn off automatically, the
symbol will turn off, AUTO will flash and a buzzer will be sound, which can be
turned off by pushing any of the buttons except the
Turn the switch and thermostat knobs to zero and put the programmer onto
"manual" by pressing the
Attention
After a power cut the clock resets to zero and cancels the set
programs. After a power cut, three zeros will flash on the display.
symbol will disappear. If after this setting, the AUTO
symbol remains illuminated.
button.
34
button (the cooking time
button (fig. 6.6); if
button.
.
/ buttons.