Table of Contents
Advertisement
Daily Start Up
CAUTION
Status Display
Heater Duty Cycle
Refrigeration Duty Cycle
(refrigerated units)
Thermo Scientific
Before starting the unit, double check all communication, electri-
cal and plumbing connections.
The blue LED on the thermostat illuminates to indicate the thermostat
is in standby.
If so, press
start is not enabled, or if the blue LED is not illuminated, use the
Initial Start Up procedure described on the previous page.
The Auto start feature is described later in this Section.
NOTE When using oil as a reservoir fluid, we recommend running the
unit at 95°C for 15 minutes to remove any moisture in the fluid.
If desired, press
Reservoir Fluid
Temperature
If desired, press
. If Auto start is enabled the unit will start. If Auto
to bring up the Status Display.
Sensor
%xx
%xx
+ 0 2 4 . 2 9
again to return to the Start Display.
Section 4 Operation
Temperature Scale
°C
(in)
Water
Reservoir Fluid
4-3
Advertisement
Table of Contents
