Preface; Compliance; Weee - Thermo Scientific A 40B Manual

Preface

Compliance

Products tested and found compliant with the requirements defined in the
EC Directives as well as Low Voltage Directive (LVD) can be identified by
the CE Mark on the rear of the unit. The Declaration of Conformity can
be found in the appendix of this manual.
The conformity assessment were performed following defined procedures
according to each applicable directive.
The council decision 93/465/EEC shall be authoritative concerning the
modules of the various phases of the conformity assessment procedures
and the rules for the affixing and use of the CE Mark), which are intended
to be used in the technical harmonization directives.
To confirm compliance with the EC-Directive 2004/108/EC
Electromagnetic Compatibility (EMC) our products were tested according
to the EMC requirements for emission and immunity for electrical
equipment for measurement, control and laboratory use.
Some electrical equipment displaying the CE Mark, e.g., monitors or
analytical instruments, can be affected if their manufacture accepts
interference, e.g., flickering of a monitor, as a minimum operating quality
with electromagnetic compatibility. We recommend a minimum distance of
approximately one meter from this type of equipment.
For any additional information, refer to the Declaration of Conformity.
Visit www.ul.com/global/eng/pages to view the UL listings for
Thermo Fisher Scientific. Reference file #E164214 for these products.

WEEE

This product is required to comply with the European Union's Waste
Electrical & Electronic Equipment (WEEE) Directive 2002/96/EC. It is
marked with this symbol.
Thermo Fisher Scientific has contracted with one or more recycling/
disposal companies in each EU Member State, dispose of or recycle this
product through them. Further information on Thermo Fisher Scientific's
compliance with these Directives is available at:
www.thermo.com/WEEERoHS
i
Thermo Scientific