User Detect; Serial Number; Inmotion - (Ready To Run) - Technogym RUN NOW EXCITE + Technical Service Manual

RUN NOW Excite +: Technical Service guide - rev. 6.2
9.1.18. U D
SER ETECT
This function is able to detect the presence of a user running on the tread belt during an exercise
session. It is possible to configure a minimum speed at which the machine will determine that the
user has stopped running on the treadmill, and interrupt the exercise session if the condition persists
for one minute. To change the setting, when the LED matrix shows the current duration:
Press the ENTER key to change the parameter: when the current parameter value starts to blink,
press the CLEAR key to erase the current value and then use the number keys to enter the desired
new value.
The default value of this parameter is 5.0 km/h
The minimum threshold speed for the user detect function is 3.0 km/h. Entering any
value lower than this will have the effect of disabling the user-detect function.
If the unit of measurement is setted to IMPERIAL units (miles / pound), the default
value for this parameter is 3 mph while the minimum speed is 2 mph.
At the end of the format procedure, hold down the CLEAR key for a few seconds to exit. The
CLEAR key can be pressed at any time to interrupt the procedure and revert to standby mode.
9.1.19. S N
ERIAL
This parameter shows the serial number of the machine.
9.1.20. I M
N OTION
It is possible to set how many time (in minutes) before the end of the exercise, the RED light on the
handlebar, should starts blinking to indicate the soon end of the exercise. InMotion function is
managed in minutes, with values ranging from 0 to 5.
To change the setting, when the LED matrix shows the current time:
Press the ENTER key to change the parameter: the current value of the parameter will start to blink,
at this point press the CLEAR key to erase the current value and then enter one digit at a time using
the ↑ and ↓ keys to change the value and the +/- GOAL keys to scroll to the next character.
The default value of this parameter is 1.
Setting "0" this parameter will have the effect of disabling the function.
Pagina 9.7

USER DETECT:

UMBER
– (R R
EADY TO UN
I M
N
XXX
SN:
XXXXX
)
( ):
OTION MIN X