Parameter Menu; Basic Setup Parameters - Lenze ESV251 1S Series Operating Instructions Manual

4.5

Parameter Menu

4.5.1

Basic Setup Parameters

Code
No. Name
Start Control Source
P100
Standard Reference
P101
Source
Lenze SMVector 13554876 EDBSV01 EN v21.0
Possible Settings
Default Selection
0 0 Local Keypad
1 Terminal Strip
2 Remote Keypad Only
3 Network Only
4 Terminal Strip or Local Keypad
5 Terminal Strip or Remote Keypad
6 CTRL button select
WARNING!
P100 = 0 disables TB-1 as a STOP input! STOP circuitry may be disabled if parameters are
reset back to defaults (see P199)
NOTE
• P100 = 4, 5: To switch between control sources, one of the TB-13 inputs (P121...P124)
must be set to 08 (Control Select);
TB-13x OPEN (or not configured): Terminal strip control
TB-13x CLOSED: Local (P100 = 4) or Remote (P100 = 5) keypad
• P100 = 0, 1, 4, 6: Network can take control if P121...P124 = 9 and the corresponding
TB-13x input is CLOSED.
• The STOP button on the front of the drive is always active except in JOG mode.
• TB-1 is an active STOP input if P100 is set to a value other than 0.
• An fault will occur if the Assertion Level switch (ALsw) position does not match
F.AL
the P120 setting and P100 is set to a value other than 0.
0 0 Keypad (Local or Remote)
1 0-10 VDC
2 4-20 mA
3 Preset #1 (P131)
4 Preset #2 (P132)
5 Preset #3 (P133)
6 Network
7 Preset Sequence Segment #1 (P710) Selections 7, 8 & 9 are not valid for PID setpoint
8 Preset Sequence Segment #2 (P715)
9 Preset Sequence Segment #3 (P720)
Commissioning
Use RUN button on front of drive to start
Use start/stop circuit wired into the terminal strip.
Refer to section 3.2.3
Use RUN button on optional Remote Keypad to start
• Start command must come from network
(Modbus, CANopen, etc)
• SMV models <15HP (11kW) require optional
communication module (refer to the network
module documentation).
• Must also set one of the TB-13 inputs to 9
(Network Enable); see P121...P124
Allows start control to be switched between
terminal strip and local keypad using one of the
TB-13 inputs. See note below.
Allows start control to be switched between
terminal strip and optional remote keypad using
one of the TB-13 inputs. See Note below
Allows start control to be switched between
terminal strip and local keypad using the CTRL
button.
NOTE: P100 Selection 6 is applicable to SMV 15HP
(11kW) and higher models only.
Selects the default speed or torque reference
when no Auto Reference is selected using the
TB-13 inputs.
or torque reference.
IMPORTANT
27