Commissioning; Local Keypad & Display - Lenze ESV251 1S Series Operating Instructions Manual

4

Commissioning

4.1 Local Keypad & Display
SMV Models: 0.33-10HP (0.25-7.5kW)
AUTO
4-Character Display
Display START BUTTON
In Local Mode (P100 = 0, 4, 6), this button will start the drive.
RUN
STOP BUTTON
Stops the drive, regardless of which mode the drive is in.
WARNING!
STOP
When JOG is active, the STOP button will not stop the drive!
ROTATION
In Local Mode (P100 = 0, 4, 6), this selects the motor rotation direction:
- The LED for the present rotation direction (FWD or REV) will be on
- Press R/F; the LED for the opposite rotation direction will blink
- Press M within 4 seconds to confirm the change
- The blinking direction LED will turn on, and the other LED will turn off
When rotation direction is changed while the drive is running, the commanded direction LED will blink until the
drive is controlling the motor in the selected direction.
Rotation is set in P112. When P112 = 0, rotation is forward only. When P112 = 1 rotation is forward and reverse.
MODE
Used to enter/exit the Parameter Menu when programming the drive and to enter a changed parameter value.
UP AND DOWN BUTTONS
Used for programming and can also be used as a reference for speed, PID setpoint, or torque setpoint.
When the p and q buttons are the active reference, the middle LED on the left side of the display will be on.
Lenze SMVector 13554876 EDBSV01 EN v21.0
Commissioning
FWD
REV
RUN
STOP
SMV Models: 15HP (11kW) and greater
REMOTE MAN
CTRL
LOCAL
AUTO
AUTO
4-Character plus CTRL Display
Hz RPM
% AMPS
/UNITS
FWD
RUN
REV
STOP
23