Table of Contents
Advertisement
AXIS Q6075-S PTZ Network Camera
Specifications
CAUTION
Hot surface. Risk of injury. Don't touch the product when it's in operation. Disconnect from power supply and allow
the surfaces to cool before performing maintenance on the product.
NO
NOTICE
NO
TICE
TICE
• Risk of damage to SD card. Don't use sharp tools, metal objects, or excessive force when inserting or removing the SD card.
Use your fingers to insert and remove the card.
• Risk of data loss and corrupted recordings. Unmount the SD card from the device's web interface before removing it.
Don't remove the SD card while the product is running.
This device supports SD/SDHC/SDXC cards.
This device supports microSD/microSDHC/microSDXC cards.
This device supports microSD/microSDHC/microSDXC cards (not included). For information about limitations and updates, see
the device's release notes.
For SD card recommendations, see axis.com.
For SD card recommendations, see axiscompanion.com.
SD, SDHC, and SDXC Logos are trademarks of SD-3C LLC. SD, SDHC and SDXC are trademarks or registered
trademarks of SD-3C, LLC in the United States, other countries or both.
microSD, microSDHC, and microSDXC Logos are trademarks of SD-3C LLC. microSD, microSDHC, microSDXC are
trademarks or registered trademarks of SD-3C, LLC in the United States, other countries or both.
Buttons
Control button
The control button is used for:
•
Enabling the Focus Assistant. Press and very quickly release the Control button.
•
Calibrating the speaker test. Press and release the control button and a test tone is played.
•
Resetting the product to factory default settings. See Reset to factory default settings on page 89.
•
Ensuring the camera is level. Press the button for not more than two seconds to start the leveling assistant and press
again to stop. The status LED and buzzer signal (see ) assist leveling of the camera. The camera is level when the buzzer
beeps continuously.
•
Ensuring the camera is level. Press the button for not more than two seconds to start the leveling assistant and press again
to stop. The buzzer signal (see ) assist leveling of the camera. The camera is level when the buzzer beeps continuously.
•
Resetting the product to factory default settings. See or
•
Connecting to an AXIS Video Hosting System service. To connect, press and hold the button for about 3 seconds until the
status LED flashes green.
•
Connecting to a one-click cloud connection (O3C) service over the internet. To connect, press and hold the button
for about 3 seconds until the status LED flashes green.
74
Advertisement
Table of Contents
