Axis Q6075-S User Manual page 90

AXIS Q6075-S PTZ Network Camera
Troubleshooting
9. The process is now complete. The product has been reset to the factory default settings. If no DHCP server is available on
the network, the default IP address is 192.168.0.90-93.
10. The process is now complete. The product has been reset to the factory default settings. If no DHCP server is available on
the network, the default IP address is 192.168.0.90-95.
11. Use the installation and management software tools to assign the IP addresses, set the password and access the video
stream.
Note
To reset a single channel to the original factory default settings, log in to the device's web interface and use the provided
button.
1. Press and hold the control button and the power button for 15–30 seconds until the status LED indicator flashes amber.
See Product overview on page 69.
2. Release the control button but continue to hold down the power button until the status LED indicator turns green.
3. Release the power button and assemble the product.
4. The process is now complete. The product has been reset to the factory default settings. If no DHCP server is available on
the network, the default IP address is 192.168.0.90.
5. Using the installation and management software tools to assign an IP address, set the password and access the video
stream.
1. Press and hold the control button and the power button. See Product overview on page 69.
2. Release the power button but continue to hold down the control button for 15–30 seconds until the status LED indicator
flashes amber.
3. Release the control button.
4. The process is now complete. The product has been reset to the factory default settings. If no DHCP server is available on
the network, the default IP address is 192.168.0.90.
5. Using the installation and management software tools, assign an IP address, set the password and access the video stream.
1. Disconnect power from the product.
2. Press and hold the control button while reconnecting power. See Product overview on page 69.
3. Keep the control button pressed for 25 seconds until the status LED indicator turns amber for the second time.
4. Release the control button. The process is complete when the status LED indicator turns green. The product has been reset
to the factory default settings. If no DHCP server is available on the network, the default IP address is 192.168.0.90.
5. Use the installation and management software tools, assign an IP address, set the password, and access the product.
1. Disconnect power from the product.
2. Press and hold the control button while reconnecting power. See Product overview on page 69.
3. Keep the control button pressed for 10 seconds until the status LED indicator turns amber for the second time.
4. Release the control button. The process is complete when the status LED indicator turns green. The product has been reset
to the factory default settings. If no DHCP server is available on the network, the default IP address is 192.168.0.90.
5. Use the installation and management software tools, assign an IP address, set the password, and access the product.
You can also reset parameters to factory default through the device's web interface. Go to Maintenance > Factory default and
click Default.
90