Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Axis Manuals
  4. Security Camera
  5. Q60-E Series
  6. Repainting instructions

Axis Q60-E Series Repainting Instructions

Ptz network camera
Hide thumbs Also See for Q60-E Series:

Advertisement

Quick Links

Download this manual
AXIS Q60-E Series
AXIS Q6074-E PTZ Network Camera
AXIS Q6075-E PTZ Network Camera
Repainting Instructions

Advertisement

loading

Related Manuals for Axis Q60-E Series

Summary of Contents for Axis Q60-E Series

  • Page 1 AXIS Q60-E Series AXIS Q6074-E PTZ Network Camera AXIS Q6075-E PTZ Network Camera Repainting Instructions...

  • Page 2: Impact On Warranty

    Risks with repainting There are several risks when disassembling or assembling an Axis product. There is always a certain yield loss during assembly. Training of operators and the use of correct tools mediates some of the problems but they can never be fully avoided. Some of the risks include: ESD Damage - Always handle the product in an ESD safe environment.

  • Page 3: Pretreatment Of Parts

    Clean the parts properly to remove oil, grease and dust. For more information on the materials used in the product, see its datasheet at www.axis.com Powder coated parts - Use a primer. Alternatively, remove the original powder coating down to the base material, using fine sandpaper, and clean the parts before painting.
  • Page 4 AXIS Q60-E Series Repaint the product Disassembly 1. Remove the dome module assembly (4 screws). 2. Remove the four screws and separate the dome module bracket, dome with dome module sealing and dome cover ring from each other.
  • Page 5 AXIS Q60-E Series Repaint the product 3. Loosen the unit assembly (3 screws). 4. Lift the unit assembly upwards and remove the connector from the PCB assembly power by pulling the connector upwards. Repainting...
  • Page 6 2. Mask the entire opening in the bottom of the chassis. Make sure that the masking line is close to the original paint border so that no paint particles can reach the inside of the camera. Outline drawing of the opening can be found on www.axis.com.
  • Page 7 AXIS Q60-E Series Repaint the product Reassembly 1. Attach the connector to the PCB assembly power. 2. Reassemble the unit assembly (3 screws, 4 N m).
  • Page 8 AXIS Q60-E Series Repaint the product 3. Assemble the dome module bracket, dome with dome module sealing and dome cover ring (4 screws, 1.2 N m).
  • Page 9 AXIS Q60-E Series Repaint the product 4. Reassemble the dome module assembly (4 screws, 4 N m).
  • Page 10 Repainting Instructions Ver. M2.2 AXIS Q60-E Series Date: December 2019 © Axis Communications AB, 2019 Part No. T10146596...

This manual is also suitable for:

Q6074-eQ6075-e