Rubber Feet Replacement - Lenovo ThinkEdge SE350 V2 User Manual

Figure 95. Installation of a processor heat sink
After this task is completed
• Proceed to complete the parts replacement (see "Complete the parts replacement" on page 161).
Demo video
https://www.youtube.com/watch?v=67oVnQqaM5E

Rubber feet replacement

Follow instructions in this section to remove or install the rubber feet (4 rubber pads).
Note: A set of rubber feet (4 rubber pads) can be mounted to the underside of a node or node sleeve.
Remove the rubber feet
Follow instructions in this section to remove the rubber feet (four rubber pads) from a node or node sleeve.
About this task
To avoid potential danger, make sure to read and follow the safety information.
• S002
ThinkEdge SE350 V2 User Guide
130