Lenovo ThinkEdge SE350 V2 User Manual page 156

Notes:
• The machine type needs to be updated if the node is to be installed in an enclosure, or is removed
from and not to be reinstalled to an enclosure (see
enclosure" on page
• Machine type number and serial number can be found on the ID label (see
access the Lenovo XClarity Controller" on page
6. If the node is with SED installed, recover the SED AK (see
Authentication Key (SED AK) " on page
7. If necessary, update the public key (see the "Update Key" section in
Management Mobile Application User Guide
8. If necessary, set the TPM policy (see
9. If necessary, enable Secure Boot (see
Demo video
https://www.youtube.com/watch?v=RYT8glyqKCc
Install a bridge board
Follow instructions in this section to install a bridge board.
About this task
To avoid potential danger, make sure to read and follow the safety information.
• S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off
the electrical current supplied to the device. The device also might have more than one power cord.
To remove all electrical current from the device, ensure that all power cords are disconnected from
the power source.
Attention:
• Read "Installation Guidelines" on page 37
you work safely.
• Touch the static-protective package that contains the component to any unpainted metal surface on the
node; then, remove it from the package and place it on a static-protective surface.
Procedure
Step 1. Make preparations for this task.
a. Make sure the system board is installed (see
on page 144).
ThinkEdge SE350 V2 User Guide
148
157).
133).
).
"Set the TPM policy" on page
Enable UEFI Secure
and "Safety inspection checklist" on page 38
"Change the machine type for operating in an
33).
"Manage the Self Encryption Drive
ThinkShield Edge Mobile
155).
Boot).
"Install a system board (trained technician only)"
"Identify the server and
to make sure that