Lenovo ThinkEdge SE350 V2 User Manual page 95

Figure 61. Installation of the drive cage
Step 3. Tighten the four screws as illustrated.
Figure 62. Installation of the drive cage screws
After this task is completed
• Connect all necessary cables to the drive backplane(s) (see
page 165).
Attention: Before connecting the drive-backplane cables, make sure that the power input board module
and the power module board are installed in place.
• Install the top cover to the node (see
enclosure (see "Install a node to the rack" on page
"Cable routing for the hot-swap drives" on
"Install the top cover" on page
52).
160) or install the node into an
.
Chapter 5 Hardware replacement procedures
87