Lenovo ThinkEdge SE350 V2 User Manual page 44

Power button location and power LED are specified in:
• Chapter 2 "Server components" on page 17
• "Troubleshooting by system LEDs" on page 187
The server can be turned on (power LED on) in any of the following ways:
• You can press the power button.
• The server can restart automatically after a power interruption.
• The server can respond to remote power-on requests sent to the Lenovo XClarity Controller.
Note: The management processor interface can be accessed to configure the system without powering
on the server. Whenever the server is connected to power, the management processor interface is
available. For details about accessing the management server processor, see "Opening and Using the
XClarity Controller Web Interface" section in the XCC documentation compatible with your server at
https://pubs.lenovo.com/lxcc-overview/
6. Validate the server. Make sure that the power LED, Ethernet connector LEDs, and network LEDs are lit
with green light, which means the server hardware has been set up successfully.
See "System LEDs and diagnostics display" on page 27
Configure the system
Complete the following procedures to configure the system. For detailed instructions, refer to
"System configuration" on page
1. Set the network connection for the Lenovo XClarity Controller to the management network.
2. Update the firmware for the server, if necessary.
3. Configure the firmware for the server.
4. Install the operating system.
5. Back up the server configuration.
6. Install the applications and programs for which the server is intended to be used.
ThinkEdge SE350 V2 User Guide
36
.
175.
for more information about the LED indications.
Chapter 7